Components Needed
Milwaukee battery clip connected to the custom diagnostic splitter (with deutsch plugs labelled BATT, INPUT, POWER)
2. Blindsight BPU with Blindsight harness
All components connected below
How to test Blindsight without vehicle power?
Connect Milwaukee battery clip to the deutsch plug labelled BATT on your custom diagnostic splitter (with deutsch plugs labelled BATT, INPUT, POWER).
The splitter allows power from the Milwaukee battery to be distributed to multiple components.
Connect the deutsch plug labelled "POWER" to the Blindsight harness.
The Blindsight harness receives and provides power to Blindsight.
Connect the power connecter from the Blindsight harness into the BPU.
Monitor Results.
The red and green status lights on the BPU should both turn on within a few seconds (this means Blindsight is booting).
If the status lights do not turn on, please check Milwaukee battery is fully charged.
If your battery is charged then there is an issue with the Blindsight hardware. Please contact Presien support.