Skip to main content

Blindsight Pre-Start Procedure

Support avatar
Written by Support
Updated over a month ago

The information in this article is duplicated in our Operator Training Video here.



1. Turn on ignition and wait 2 minutes for Blindsight to boot

            The in-cab status light will be red during this time

2. While you wait for Blindsight to boot, visually inspect the cameras

  • Check for damage and dirt that may impair the camera's vision


  • Ensure they are angled correctly. i.e. not facing the sky or too far down

  • Ensure cables are not damaged

3. After waiting 2 minutes, confirm the in-cab status light is green or yellow

4. Activate and deactivate the vehicles alert trigger. The status light should change from green to yellow

Green = Alerts enabled

Yellow = Alerts disabled

5. Safely trigger an alert by enabling the alert trigger and have someone walk in the alert zone

6. If the in-cab alert stays red after 2-3 minutes, please report to your Health & Safety Supervisor for troubleshooting.

Did this answer your question?